The ``-t'' flag sets the program in List mode.
backupst -t [options]
The List mode does not have special options. Only the general
options apply.
The following options are available in all modes:
- -da
Use drive A as the backup drive. This is a default option.
- -db
Use drive B as the backup drive
- -s1
Use single sided floppies
- -s2
Use double sided floppies. This is a default option.
- -v
Verbose mode. This option has no use to the normal user,
only to the programmer. You are not advised to use this
option, it will slow down the backup.
- -j#
No of sectors per track. The only valid numbers are
9 and 10. If you restore or list an archive, this option
may be supplied but is overruled by the values stored in
the archive info. 9 sectors per track is the default
value.
- -k#
No of tracks per side. The only valid numbers are
80-84. If you restore or list an archive, this option
may be supplied but is overruled by the values stored in
the archive info. 80 tracks per sector is the default
value.
BackupST will list all the data found in the archive. If
BackupST is functioning in list mode, the data listed will
be piped through more. After every full page of data, you must
press a key to see the next page full of data.